Electrolux (Alno) EBB3200MG XPH Manuel d'utilisateur télécharger pdf (Page 3)

INITIAL START UP

When in operation, the outside of the refrigerator will feel

warm, particularly at start up. This is normal.

Avoid placing food against air outlets as this will impede

air circulation.

A light frosting will occasionally occur on the cold interior

of the freezer if the door is opened frequently. This is

normal and the frost will disappear after a few days in

most climates.

Make sure that the freezer and fresh foods doors are

fully closed after you have loaded or removed food from

these compartments. If the doors are left partly opened, a

heavy frost will coat the inside of the freezer. If this occurs,

remove the frost. Ensure that all doors are properly closed

to prevent frost from reappearing.

Your refrigerator uses energy efficient components that

may produce different noises (Refer “Noises” page for

examples) from your old refrigerator. Occasionally, a

gurgling sound of refrigerant flowing or sound of parts

expanding or contracting can be heard. These noises are

quite normal.

CLEANING

Exterior

Clean the refrigerator with only lukewarm soapy water

and a soft cloth. Rinse the clean water and then wipe

the surface with a soft clean cloth to remove any soap

residue.

Interior

Clean the refrigerator interior regularly. Turn power off.

Wipe the interior with a soft cloth and lukewarm soapy

water. Thoroughly dry all surfaces and removable parts.

Avoid getting water on the refrigerator controls. If you

have taken out any removable parts, replace them and

switch on the power before re-stocking the refrigerator.

Wipe away thoroughly any food spills.

Keep door seals clean

Ensure that the door seals are always clean. Sticky food

and drinks can cause seals to adhere to the cabinet and

may cause tear when opening the door. Wash seals with

lukewarm soapy water. Rinse thoroughly and dry.

Never use hot water, solvents, commercial kitchen

cleaners, aerosol cleaners, metal polishers, caustic or

abrasive cleaners or scourers to clean the appliance

as they will damage it. Many commercially available

cleaning products and detergents contain solvents that

will damage your refrigerator. When cleaning, use only a

soft cloth and lukewarm soapy water.

WARNING

INSTALLATION

Clean the refrigerator thoroughly according to instructions

and wipe away any dust that has accumulated during

shipping.

Check that the floor is level. If it is not, adjust the stabilising

foot so that the refrigerator is level and stable.

We recommend that the refrigerator be turned on and

left to run for two to three hours before placing any food

inside it. This will allow you to check that it is operating

properly and there is adequate cool air in the freezer.

Installation clearances

• Allow a minimum of 30mm clearance on both sides of

the refrigerator.

• Allow a 50mm clearance at the back of the

refrigerator.

• Allow a minimum of 10mm clearance above the

hinge cover.

• If you do not have a cupboard with allowance

for air flow above the refrigerator, the

recommended clearance at the top of the

refrigerator is 90mm.

• When positioned in a corner, the clearance must be

at least 350mm on the hinge side to allow the door

to open smoothly so that bins and shelves can be

removed easily.

Note: Refrigerator doors on all models are designed to sit

proud of cabinetry (not flush). The refrigerator should be

placed against a wall and the clearance between the rear of

the refrigerator and the wall should be greater than 75mm.

Installing and Cleaning the Refrigerator

R600A REFRIGERANT WARNING

• This appliance contains flammable R600a refrigerant.

Avoid safety hazards by carefully installing, handling,

servicing and disposing of this appliance. If your

appliance contains R600a it will be indicated on the

rating plate inside the appliance.

• Ensure that the tubing of the refrigerant circuit is not

damaged during transportation and installation.

• In the event any damage accidentally occurs, keep the

appliance away from open fires and any devices that

produce sparks or arcs and luminaries during normal

or abnormal operation, and unplug the appliance at the

power point. Call authorized service for necessary

action and advice.

• Leaking refrigerant may ignite vent area if leak occurs.

• The room for installing appliance must be at least

per 8g of refrigerant. The amount and type of

refrigerant in the appliance can be found on the rating

plate inside the appliance.

• Do not damage the refrigerant circuit.

• Do not use electrical appliances inside the food

storage compartments of the appliance, unless they

are of the type recommended by the manufacturer.

• Keep ventilation openings, in the appliance enclosure

or in the built-in structure, clear of obstruction.

• Do not use mechanical devices or other means to

accelerate the defrosting process, other than those

recommended by the manufacturer.

• Do not use a steam cleaner to clean the appliance. If

live components come in contact with the condensing

steam, they may short circuit or cause an electric

shock.

• Keep ventilation openings, either in the appliance

enclosure or in the built-in structure, clear of

obstruction.

• Do not plug the appliance into a timer fitted to the

power point.

• Do not place your appliance on an uneven surface.

• Do not store explosive substances such as aerosol

cans with flammable propellant in the appliance.

• Do not store fizzy drinks in the freezer compartment.

• Never try to repair the refrigerator on your own. Use

only a qualified or authorised service person for repairs.

• Never use electric heaters or dryers to defrost the

freezer because you can receive an electric shock.

• Do not use mechanical devices or other means to

accelerate the defrosting process, other than those

recommended by the manufacturer.

• Do not damage the refrigerant circuit.

• Do not use electrical appliances inside the food storage

compartments of the appliance, unless they are of the

type recommended by the manufacturer.

WARNING

Stable Footing

When your refrigerator is in place, you need to stabilize

it. Lift the front of the refrigerator to take the weight off

each stability foot and make small quarter turns to each

foot until it is in firm contact with the floor. If you intend to

move the refrigerator, remember to wind up each foot so

that you can move it freely. Repeat the process of the foot

adjustment once you have settled on the new location of

the refrigerator.

Conditions of use

This appliance is intended to be used in household and

similar applications such as,

• Staff kitchen areas in shops, offices and other working

enviroments;

• Farm house and by clients in hotels, motels and other

residential type enviroments;

• Bed and breakfast type environments;

• Catering and similar non-retail applications

WARNING

Stabilising

foot wound

down

Side View

10mm

1 2 3 4 5 6 7 8 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Electrolux (Alno) EBB3200MG XPH Manuel d'utilisateur Page 3

Commentaires sur ces manuels